Inner:bubble poly bag,outer:5 layers ctn box or poly wooden box/pallet
Logistics service
sea,air,express,EXW,FOB,CIF,DDU,DDP
Certifcations
ISO 9001
warranty
100% refund or replacement for NOK pcs
Bending 89 mm stainless tube is not the difficult part. The difficult part is the crossover: on the F97 and F98 the Z section has to cross the transmission tunnel, clear the floor brace, miss the driveshaft and the rear subframe, and still deliver both banks to the merge point at the correct angle and length for the pulses to arrive in phase. Pattern parts that approximate that geometry fail in one of two ways -- they contact the brace under load and rattle, or the merge is wrong enough that the engine develops a flat spot the buyer blames on the pipe diameter.
So the build process is the product. Flanges are laser-cut so the mating face is flat and does not warp under weld heat, which is what causes a leak you can hear but cannot find. Bends are CNC mandrel-formed to a repeatable centreline radius rather than hand-bent, so tube 1 and tube 500 have the same geometry. The assembly is then welded in a fixture, not fitted up by eye on a bench: that is what guarantees the hanger positions, and hanger position is the difference between a pipe that hangs in its rubber isolators with no preload and one that is stressed into place and transmits every vibration into the cabin floor.
Welding is TIG with argon back-purge on the internal joints, followed by a pressure and leak check before packing. On an exhaust this matters beyond cosmetics: an internal weld that sits proud in the gas path, or a pinhole at a seam, is a flow disturbance or a whistle that no amount of clamping will fix.
Fitting notes worth having in advance. Use new gaskets rather than reusing the originals, check clearance to the floor brace and subframe before final torque, and re-torque the flange fasteners after the first heat cycle -- stainless grows and settles, and a joint that was tight cold will often need a second pass when hot. Do not over-tighten the clamps; deformed tube at a joint is a leak path.
The section sits behind the factory catalysts, so emission hardware is untouched, and the exhaust valves continue to work, keeping Comfort civil. If drone at a steady cruise is your concern rather than outright volume, ask for the resonated variant -- same geometry, with a branch that targets the boom frequency. Custom diameters and laser-etched branding available to order. That's Fupower. Custom everything.