News

Working From a 3D File: Format, Scale and What Still Has to Be Checked
2026-10-13
A 3D file carries geometry but not tolerance intent, finish or material. Covers formats that translate cleanly, unit and scale errors, features to review and the route to a mould.
Working From a Sample Instead of a Drawing
2026-10-13
When there is no drawing, the sample goes to an engineer who gauges the dimensions and produces one. Covers measuring, sample versus big moulds, confirmation and where this route fits.
Exhaust Gaskets and Hardware: What to Replace When You Swap a Section
2026-10-13
A joint loses its seal the moment it is opened. Covers gasket materials, bolts, studs, clamps and flanges, what to inspect on the mating faces, and when reuse is acceptable.
Drone and Resonance: What Causes It and What Changes It
2026-10-13
Drone is a resonance that lines up at one road speed, not simple volume. Explains cabin amplification, muffler internals, reflected pulses and which changes genuinely reduce it.
Catch Cans: What They Separate and Why Placement Matters
2026-10-13
A catch can separates oil mist from crankcase vapour by slowing the flow and letting droplets settle. Covers where the vapour comes from, clean side versus pressure side, mounting and drainage.
Air Filters and Prefilters: What Each One Is For
2026-10-13
How an air filter and a prefilter differ in position and purpose, how the working environment sets service intervals, and how to pair the two on a working car.
Intake Pipe Diameter: What Changing It Does to the Rest of the System
2026-10-13
What intake pipe diameter controls, why larger and smaller bores both have limits, and how joints, bends and the rest of the intake chain decide the real result.
Custom Silicone Hose for a One-Off Build
2026-10-13
When a one-off build needs a custom silicone hose, what to send with the enquiry, how the sample and drawing routes work, and how to check the first part made.
Page 27 of 36
Total 36 Pages
Go To